Cisco Air-AP1252ag -- 15.2 can't get multiple SSIDs advertising properly

Cisco Air AP1252AG 15.2 is a wireless access point (AP) designed to provide wireless coverage in enterprise networks. It is a multi-functional device that can be used to provide both wireless access and wireless mesh networking capabilities. It is an 802.11a/b/g/n/ac compatible access point capable of delivering up to 1.3 Gbps data throughput.

In this article, we will discuss the issue of why multiple SSIDs are not advertising properly on the Cisco Air AP1252AG 15.2. We will also provide some possible solutions.

The first step when troubleshooting any wireless network issue is to confirm the environment. It is important to ensure that the AP is connected to the network and has the necessary power, such as PoE or direct power. Then, check to make sure the SSIDs are configured correctly and the radio settings are correct.

One possible issue when trying to get multiple SSIDs to advertise on the Cisco Air AP1252AG 15.2 could be that the radio settings are incorrect. The radio settings include the radio mode, channel, and power settings. It is important to ensure that the radio settings are configured to the correct mode and channel, as well as an appropriate power level. This can usually be done by logging into the web-based management interface of the access point.

Another possible issue could be that the SSIDs are not configured correctly. This is especially true if the access point is being used in a mesh network. In this case, the SSIDs must be configured to the correct mesh network settings. This includes the mesh ID, mesh authentication type, and mesh encryption type.

One final issue that could be causing the problem is if the antenna is not properly aligned. If the antenna is not properly aligned, it could be causing the signal to be weaker or not reach to the desired locations. This can be corrected by adjusting the antenna or using a directional antenna.

In conclusion, there are several possible causes as to why multiple SSIDs are not advertising properly on the Cisco Air AP1252AG 15.2. It is important to investigate the environment and make sure the radio settings are correct, the SSIDs are configured correctly, and the antenna is properly aligned. If all of these issues are addressed, then the problem should be resolved.